8mm - DRY SET MASONRY REPAIR

Brick to Brick / Mortar Joint


SPECIFICATION:

All brick veneer is to be stabilized in a dry set manner by means of a 8mm helical 304 stainless steel remedial wall tie.


INSTALLATION PROCEDURES:

Install helical stainless steel ties (dry set technique) at specified spacing. Patch all penetrations to match existing as approved by the specifier. Install helical ties as per the following procedures:
  • An 5mm entry hole shall be drilled through the mortar joint by means of a high speed rotary percussion drill (3 jaw chuck type).
  • These entry holes shall occur at the approximate centre of the brick (not the T joints or end).
  • The 8mm helical tie shall then be driven into position by means of a BLOK-LOK® dry set power tool mounted on an electric hammer drill (S.D.S. type).

All relevant drill bits and setting tools shall be supplied by BLOK-LOK® Ltd.



BLOK-LOK® Limited
30 Millwick Drive | Weston ON | Canada | M9L 1Y3
Phone #: (416) 749-1010 | Fax #: (416) 749-1017 | U.S.: (800) 561-3026
E-mail: sales@blok-lok.com


[CLOSE WINDOW]